SlotForum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 25 Results
  1. Scalextric ARC PRO
    I’ve just received a lemans Arc Pro set from Amazon that’s clearly come from the states, rather than going through the motions of sending it back, I’d rather bite the bullet and purchase an Aussie version of the transformer unless there’s an easy fix or a step up converter available. Any help...
  2. Scalextric ARC PRO
    Hi All, I have just set up a track with my new christmas presents. It works fine in manual mode, excluding driver error. The problem is when setting up pace cars there is a massive increase in power after the ARC pro and the cars come flying off. I am running them as slow as possible but there...
  3. Digital
    Hi all, I have an Arc pro and frequently when the controller rumbles it disconnects from the power base. It does not happen with brand new 1.5v alkaline batteries, it does happen with 1.5 and 1.2v rechargeables. Oddly though I find the issue very much worst when slaved t red / channel 1.I have...
  4. Digital
    I have just setup my new ARC PRO track with a pit lane, Was just wondering what progress has been made regrading the following 1. Pit lane Speed reduction including pit lane sensors 2. Start gantry to work with the ARC Pro I did see some posts about users working on a WiFi interface has this...
  5. Digital
    Good evening community, Allow me to apologize for my ignorance in advance, but I was hoping that I might be able to inquire about utilizing a Slot.It Oxigen system with Scalextric digital track. We are currently running the following: Scalextric ARC Pro track system (50 foot running length)...
  6. Scalextric ARC PRO
    Good evening community, Having an issue, again, and would welcome some expertise. I am running the following setup on our home track: Scalextric ARC Pro track system: grey wire mod, 50 foot running length RevoSlot cars Slot.It SP15c SSD with FM direct solder to motor side of chip Slot.It SPC3...
  7. Scalextric Digital (APB, ARC PRO)
    Greeting community... me again! I am writing this afternoon in hopes that I can absorb some of your knowledge and expertise. I am in the process of retrofitting a Slot-It Audi 4wd e-tron with a SP15c SSD to run on a SCALEXTRIC ARC Pro track. After opening the Audi, though the box stated "SSD...
  8. Slot.it oXigen
    I recently purchased two Slot-It SCP-3 controllers to run an ARC Pro system. I was able to successfully register one controller, flash it to the latest "ARC" firmware, sync it to the ARC Pro base, and subsequently run a car. When I tried performing the identical setup for the second controller...
  9. Welcome & Introductions
    Greetings! I am a US Service Member stationed in Germany with my family. Though I dabbled with AFX slots in my youth, my wife and I decided to jump back in to the world of slot cars to break the COVID monotony. We decided to custom build a SCALEXTRIC ARC Pro system on a 10 foot by 6 foot...
  10. Scalextric ARC PRO
    First let me apologize for my ignorance, kind of new to slot. I am running a custom built Scalextric ARC Pro track system, and me being me (a tinkerer), I want to best that I can get out of this setup: I just ordered Slot-It SCP-3 controllers, which quickly turned my attention to their cars...
  11. Scalextric ARC PRO
    So, I have been doing laps with my son using brand new ARC Pro Wireless controllers on a couple of occasions, and find that lane changing is much more difficult than on the good old APB. To get to the bottom of this I set up a small test bench with a power tap connected from the lane rails to...
  12. Scalextric Digital (APB, ARC PRO)
    There are some (old) threads discussing power supplies, but I think it is about time for a refresher. So I am creating this thread in hope it will help newbies like myself to get some more info on power supplies. Links to old posts (even threads) that are still relevant are much appreciated. A...
  13. Scalextric Digital (APB, ARC PRO)
    Hi, all! It all started with a single starter ARC One set for my son at Christmas and now I am in knee deep to the hobby! I have been buying some older track as well as digital sets where the Powerbases has an issue or other. That means I have ended up with a bunch of track and lane changers...
  14. Scalextric Digital (APB, ARC PRO)
    Hi guys would like some help I have had a the arc pro for about 1.5years now and love it, just a newbie to ssd I just set up a permanent track in my attic space above my shed …..but now my arc pro doesn't count laps?? lane changers work and pit line chargers work but no laps are...
  15. Scalextric ARC PRO
    I wrote a quick-fire introduction to the official ARC app for the Scalextric Advent Calendar in December: www.scalextric.com/uk-en/btcc-race-scalextric-arc The article looks at a BTCC race simulation for ARC Pro and covers: Setting up an Endurance Race Setting up the cars in the app so they...
  16. Track Plans
    New poster here, coming back into the hobby after a 30+ year break (last set was a Scalextric 400 with 6 wheel March). I'm embarking on a 3-board fold-away project to allow me to race Scalextric with son and daughter. Each board is 1600mm x 600mm, with 18mm ply framing. I've gone ahead and...
  17. Scalextric ARC PRO
    A couple of weeks ago I did a corparate job with with my Arc Pro. It was at an Automotive training college and so the apprentices on their break natually found the track. My client welcomed them to have a go at digital slot car racing and boy did they have a go. I was amazed at how resilient the...
  18. Events
    Scalextric and DiSCA are pleased to present; Two days of digital BTCC action at the Hornby Visitor Centre. Test your skills in a series of intense races to claim the title of touring car champion! Venue Hornby Visitor Centre Westwood Industrial Estate, Margate CT9 4JX The circuit will be a...
1-20 of 25 Results
Top