SlotForum banner
1 - 5 of 5 Posts

Premium Member
475 Posts
Discussion Starter · #1 ·
I am currently inspired by topics on this section of the forum and the prospect of running a retro formula 1
series at our club restoring some old Scalextric and MRRC cars.
One of the problems I run up against is the poor size of the drivers helmet in these early cars.
On the picture below I illustrate my point, on the left is the early head and on the right the later head which is far too large.
The head in the middle whilst not perfect is a reasonable compromise. As supplies of these are hard to come by does anyone
cast a resin head of this size and type?

Or is there another source of heads I should consider?

thanks for reading this, any help appreciated.

1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.