SlotForum banner

A Funny Thing

839 Views 3 Replies 3 Participants Last post by  GregK
Tonight I was re-working an old Fabia to get it flashed with Incar-PRO ..... the pre-flash test was fine. Added the socket for connecting to the PIC programmer, connected the lights to the various points as shown on the chip; so far so good.

Flashed the car, disconnected the programmer and re-ID'd the car. The lights all came on as expected, the brake lights worked but ....... the motor did not run. Everything appeared to be normal except there was no motion. After approximately five minutes of gently cursing and pouring a nice cold G & T ........ I spotted it View attachment 9337
The tiny resistor had parted company with the PCB at one end ....... a little pressure with a screwdriver and a gentle dab with the soldering iron and Hey Presto, the motor burst back into life ........ what a relief.
1 - 1 of 4 Posts
Looks like the G&T did the trick! Will have to remember that one for the future
See less See more
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.