[Saviour]

Hi All. Could someone please explain this.
Controller A Club Parma Economy Hand Controllers 15OHMS
Controller B My Parma Plus 15Ohms

Tested all 5 controllers, all test at 15Ohms +/-1Ohm
Ciub Controllers way quicker than Mine.
Mine way better breaking.
All 6 wired the same way

Why?
I would have thought that Parma Plus would be the quicker than Economyl, but they all should be the same as they are all 15Ohms.

Cheers
Andy

 

[Saviour]

Cheers Phil, I'll give that a try.

 

[Saviour]

After striping my Turbo down, giving it a real good clean and putting back tight. I will be testing today, so will post my finding later. Doing a bit of testing at our club track, so can compare times with both set of controllers.

 

[Saviour]

QUOTE (RichD @ 10 Jul 2012, 15:36) <{POST_SNAPBACK}>The best way to compare the controllers is to measure the voltage across the track rails with a motor running. An open circuit voltage measurement will not tell you much. My own controller has a relay that bypasses everything, including most of the wires when the controller is in the full speed position.

OK, I'll try that.
After playing about I can see that the clean was well worth it. No difference I could see on FULL but under breaking a big difference. The car stops, rather than creeps to a stand still.
I have ben used to running without breaks, but as the rest all have breaking, I would be at a loss if I did not have it. You get deeper into a corner.
Still, Race night tomorrow, we will see how it coes better then.