SlotForum banner

Adding Choke to controller

5138 Views 23 Replies 10 Participants Last post by  RichD
Hi all I have several controllers with variuos controlls ie brakes, sensitivity, traction control etc but would like to add a choke switch preferably on the wire cables so that I can quickly change the max voltage for a technical section of track. Ideally also with a dial to dial in the desired voltage for the switch to use (ie 9 or 10 volts).

Are there any parts that I should consider that I could get from the local electorinics shop.


Team Thunderbird
1 - 3 of 24 Posts
would it be any trouble to put up a wiring diagram 12 pole with 6amp diodes for a completely clueless electrical moron. i dont even know where you,d wire it in. thanks john.
thanks phil, i had to read it about 7 times to let it sink in [i,m that bad with electronics] soldering chassis, turning wheels ect i,m not bad at. but anything more than hooking up a motor brings me out in a cold sweat. cheers john.
it certainly does phil, thanks for the time an effort to explain it to me. many thanks john.
1 - 3 of 24 Posts