SlotForum banner

Advice on building a non warping board?

2213 Views 10 Replies 6 Participants Last post by  AAWSCC
Hi guys

A friend is planning to build a two tier layout for his Scalextric track and railway layout. Each will be on a separate board approx 7 ft square. To make best use of available space (and to secure domestic approval!!!!!) the layouts have to be movable. In use, they will sit across a couple of single beds. When not in use they will be stacked on edge against a wall. The Scalextric will probably be the bottem board, with 6-7 in spacer blocks built in to allow the other board on top when he wants to use the train set. Obviously, both tracks will need to be fixed down to allow the boards to be tipped upright, and buildings/scenery will either have to be low level or removable. Why this approach? The ceilings are quite low, so there isn't room for a fold down type layout, and the room is built into a dormer roof, so a winch down layout is impractical. The boards have to be stackable, as there isn't enough room get one out of the way when you want to use the other.

Sooooooooooo...........

What we need is then to build two 7 ft square decks, that are solid enough to withstand being moved from vertical to horizontal, rigid enough not to flex or warp, and light enough to be moved.

My initial thoughts are to have a 2"x1" timber frame (with bars every 12"?) skinned with 6mm MDF top and bottem. I'd add triangular corner blocks inside the frame to increase strength. The hollow design allows wiring to be concealed. Alternatively the frame could be done in aluminium (at much greater cost....)

Has anyone out there ever attempted anything like this? Anyone got any thoughts?
1 - 1 of 11 Posts
Not had a problem with warping on any of my tracks. See my links below. 12mm MDF on a 50mm x 25mm (2" x 1") frame with a 4mm MDF base. For stacking purposes, I use laminate flooring left overs which are usually available at the local tip. I place them around the edge, this helps the cars stay on the board when deslotting, you don't have to bend down to the floor, And they are rigid enough to support the layer above. They come in anything upto 185mm (7") wide, but you just cut them down. Simples!
1 - 1 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top