SlotForum banner
1 - 1 of 1 Posts

· Nobby Berkshire
Joined
·
1,987 Posts
Nobody in their right mind - unless they have a fortune of cash to throw away - is going to replace all their wheels just to use a different screw.

2mm screws undo because the thread is stripped, or you've stripped your grubscrew or allen key. These are sdaly too easy to do if you overtighten in fear of losing a wheel. All you need to do is:

1. Pop a tiny bit of threadlock or evostick glue into the thread. End of problem.

2. Cut down your allen key to a fresh hex-face.

3. Stop over-tightening your screws.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top