SlotForum banner
1 - 2 of 2 Posts

· Julius Wilkko
Joined
·
933 Posts
Ditch all the stuff with small 1.9mm grubscrews (mainly SlotIt) and start using SlotDevil rims with proper 3mm screws.

And while you're at it you can start using tubular tyres - that is tyres with no step inside.

SlotBox

I got fed up with small SlotIt screws three years ago and moved to SlotDevil and since then never looked back.

Cheers!

Julius
 

· Julius Wilkko
Joined
·
933 Posts
Below is a comparison with SlotIt type rim and SlotDevil tubular rim.

"Tube" rim has several advantages.

1. Bigger grub screw which will not wear and tear like SlotIt. Screw is 3mm, tool is 1.5mm
2. Screw hole does not take extra space allowing rim to fit wider variety of cars
3. No step is a benefit, you can have very low tyre profile
4. Easy to buy tyres, no step to consider, only outer diameter and width

Out of these #1 was the main reason for me to get rid of all the rims with small 2mm grub screws.

So far SlotDevils have had perfect fit for any car. And not a single loose rim at the competition !

Comparison picture stolen from SlotBox site



Cheers!

Julius
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top