SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I recently purchased a pre loved scalextric arc one racing set.(ultimate rivals)

I set up the track and app. Neither car works in lanes one or two. I have swapped the controller's round nothing happens despite both responding on the app when trigger has been pressed. I also vacuumed the track.

I swapped the powerbase and track for an older Sport set up, both cars worked fine.

I removed the plastic cover on the ARC powerbase to see if there were any loose connections.

Is the powerbase track faulty? Or is there something else I need to check?
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #4 ·
Thank you for the replies especially the link to the article.

I took the panel off which I noticed had a couple of loose screws and thought someone has been in here before. I noted the black and red wires had been cut and the module had been disconnected from the board.

I later found the cut module in the box! So I will be using the set up as suggested.

Thanks again.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top