SlotForum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
179 Posts
Discussion Starter · #1 ·
I need 1/8" axle spacers for my scratchbuilt (unfinished)Paxton STP car...does anyone make or supply these in brass tho' ali or stainless would be good in various lengths or design...many thanks Ken
 

·
re member
Joined
·
4,181 Posts
Nylon are available but why not make your own from brass or alloy tubing, available from the K & S rack at your hobby store.
regards
 

·
Registered
Joined
·
336 Posts
QUOTE (dragracer @ 13 Nov 2011, 13:19) <{POST_SNAPBACK}>I need 1/8" axle spacers for my scratchbuilt (unfinished)Paxton STP car...does anyone make or supply these in brass tho' ali or stainless would be good in various lengths or design...many thanks Ken

Have a look there. They have a really huge selection of tubing of many sizes.

http://www.smallparts.com/s?keywords=&.../ref=gw_c_tp_ss

Roland
 

·
Registered
Joined
·
203 Posts
QUOTE (munter @ 13 Nov 2011, 17:40) <{POST_SNAPBACK}>Nylon are available but why not make your own from brass or alloy tubing, available from the K & S rack at your hobby store.
regards
Hi Munter, any chance you would know what size tubing to use for bodypost shims. I have a rough idea but they do so many different sizes and then all with various different internal diameters as well, this tubing can be expensive to buy and I don't want end up buying the wrong size. Thanks for any help.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top