SlotForum banner

Battery replacement on Scorpius controller

1097 Views 9 Replies 5 Participants Last post by  injectorman
Hi Guys,
Place controller on table knobs side up.
Remove knobs and 3 x casing screws.
Remove casing half.
This way PCB and spacers stay in place.
Replace batteries, assemble in reverse manner.

The message here is to not take shortcut by leaving knobs on as the spacers become dislodged, making it difficult to re-assemble.

1 - 1 of 10 Posts
If you lay the controller with the knob (and screw head) side facing up when taking the two halves apart, the spacers will stay around the screw posts.
1 - 1 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.