SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
291 Posts
Discussion Starter · #1 ·
Hi
I am thinking of upgrading the rear axle bearings/bushings.
Does anyone know a good supplier of ballbearing races made for this purpose.

These will be for Scalextric standard cars to start off woth.
Also what are the dimensions need?

Cheers

Az
 

·
Registered
Joined
·
291 Posts
Discussion Starter · #3 ·
Cheers Lowrider

Try this http://members.optusnet.com.au/bpatto/gears&bearings.html
But they are very dear.
I live near a bearing manufacturer/supplier whose prices are a 1/10th of the site above.
I just need specific measurements for the scalex axles.
I have replaced hubs in the past with mixed results but I do have some spare hubs for this test.

If it works out I will then look towards getting aftermarket hubs & axles.

Cheers

Az
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top