SlotForum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
Hi all,
I was wondering if it were possible to change a standard scalextric braid pickup system into a normal pick-up where the the braids were put right into the guide flag like slot its and NSRs?
Thanks,
Nate
 

·
Registered
Joined
·
3,646 Posts
you can run the stadard guids just saw and file the guids flush on the top. bend the braids to u shape and remove. tin the tops and then solder the wires under neath the top of the braid by the front end , replace the u braid in slots and sqeeze hard with a pair of small pliers rebend the braid underneath and flat the contact surface with a fine file. job done. john.
 
1 - 5 of 5 Posts
Top