SlotForum banner
1 - 8 of 8 Posts

·
Premium Member
Joined
·
11,082 Posts
Try it on your normal APB. If that doesn't do the trick then you may well have a dead...ish chip.
 

·
Premium Member
Joined
·
11,082 Posts
Ade .... can you elaborate a bit more please? Is the problem that you can not ID on your spare APB or that cars do not run on your APB after IDing??
 

·
Premium Member
Joined
·
11,082 Posts
OK ....... does the LEDs flash on the APB? Will the car run on the base without any track connected??
 

·
Premium Member
Joined
·
11,082 Posts
Right ..... no short-circuits. Can you ID a car and run it on the APB without any track attached?
 

·
Premium Member
Joined
·
11,082 Posts
Try the controller in a different slot. When you start the APB, the Red & Green LEDs light up and stay on - no other lights should be showing. Press & hold the Enter button until the green LED flashes. At this point press the brake button on the controller - only the RED representing the controller and the Red & Green LEDs should flash. The controller LED should extinguish and the other two remain steady.

Try it without the Tower .....
 

·
Premium Member
Joined
·
11,082 Posts
Hmmm ....... nasty.

OK .... try a different throttle and no tower. The APB might think that it is in the middle of setting up a race - removing the tower should stop that.
 

·
Premium Member
Joined
·
11,082 Posts
I think that it is Ucked .......
.. sounds like a job for Rikorocket - Huzzah! ....
 

·
Premium Member
Joined
·
11,082 Posts
At least I one one bit right ......... send for Rikorocket .... Huzzah
 
1 - 8 of 8 Posts
Top