SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
232 Posts
Discussion Starter · #1 ·
Hi,
I started to tune my Carrera Bentley (old chassis version) with the tuning parts from slo.it.
Slot.it offers a tuning package for Carrera cars, that´s the one I purchased. I started to to take the car apart, removed the magnet, took the rear axel out and replaced the it with the slot.it one. Than I wanted to implement the gear, but I noticed that it is too big and touches the chassis.
No problem, started the Dremel, cut a little hole where the gear should be and it fits perfectly now, the 26 crown.
Now I wanted to put the body back on and noticed that the 26 crown is too big.

Any suggestions (and please don´t tell me to cut a hole in the body!!).

Thanks,
Nico

http://www.grenzlandslot.com
 

·
Registered
Joined
·
232 Posts
Discussion Starter · #3 ·
Hallo Thomas,
danke.
I have no problem to grind the inside of the body. Ijust would have a big problem to make a hole in the body so that the gear fits!!!!!

How about lowering the position of the axel bushing. Would that help in addition (stupid question, of course it would help) to grinding the body??

Nico

Grenzlandslot
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top