SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
43 Posts
Funny!

I tune a Carrera bentley with Slot.It parts (bushings, axle, crown, pinion and motor V12/2 23K rpm). With the old chassis I do not cut an hole on it just grind a lot to mount the crown (z=26) an put the body without screws. Start the engine slowly and increase the speed about an hour or so I notice a bump in the body. Problem solved


I even can put a bigger crown (z=27) but is need some work: fix it in an axle and carefully grind it with the Dremel.

The car behave well iin the track, but it destroy 6 (SIX) Slot.It crowns, both alluminium and brass. The problem was: the axle was not parellel to the track in one side the axle was almost 0.5mm higher
. I buy another car and solve this problem. But if I destroy another crown I will give up. I already have two Bentleys on the shelf...
 

·
Registered
Joined
·
43 Posts
QUOTE Just laughing at "notice" - as if it were a complete accident!

Yes, an accident, like the bumps in SCX Audi R8R and Dome... Be carefully and do not forget the oil!
 
1 - 2 of 2 Posts
Top