SlotForum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
300 Posts
I had a couple that wouldn't run either. The problem in the end
was my standard crappy scalextric controllers burning out and not
being able to move them !

I swapped to two Prof Motor controllers and now there fine , also tried them with
my Parma Controller (35 ohm) and they are fine with that - however with the
scalextric controllers they don't move !
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top