SlotForum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
71 Posts
Discussion Starter · #1 ·
This sounds like a really dumb question but i've just been trying for the past half hour to remove the pinion from one of my fly motors as I wish to replace it with a 12 tooth one to see how it goes.

Anyway apart from completely mangling the existing pinion has anyone got any top tips on how to remove them easily?This one just doe not seem to want to budge.

Thanks
 

·
Registered
Joined
·
71 Posts
Discussion Starter · #11 ·
Sean didnt have the Cartrix one in stock so I got the Ninco Puller. I then got my drill with a Titanium tipped bit in it and just ground away at the bar until it was thin enough to fit behind the Fly Pinion.

Cheers for the advice everyone.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top