SlotForum banner
1 - 2 of 2 Posts

· Registered
376 Posts
Discussion Starter · #1 ·
Hi Guys

I have been asked countless times "Where can I find a good chassis jig"

Well, I heard from the machine shop and I have the quote.....
Not what I was hoping for but not too bad either...

This is what I am having made up........

The jig plate is something that you can buy and make up your self using 1/16" thick aluminum or PC board...

I have used this jig and the old Russkit Adjust-O-Jig that it is based on for years, and it is one of the easiest jigs I have seen to use.... And with the addition of the jig plate and the jig wheels you can safely use a torch for all your soldering.. The jig plate set up your ground clearance and also is a nice flat surface to layout and solder your chassis parts on......

Anyone interested please contact me at [email protected] for pricing information or if you have any questions feel free to email me..

I hope to have them by the end of the month or the first of the year


1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.