SlotForum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
386 Posts
Hi

Not knowing where you are, the easiest start is to buy a motor bracket that bolts onto your motor and then just copy one of the frames you have seen here.

A simple frame consists of taking a .032 sheet of brass, tracing the body onto it, soldering the motor mount to that plate, and doing axle and guide. Fairly simple.

The Squalo has lots of room for that stuff.

Another option is to buy one of the old Atlas motor and brass carrier bits on Ebay(CHEAP). With that, a few screws and a little soldering and you are done.

Fate
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top