SlotForum banner

Cheap challenger option

1503 Views 3 Replies 3 Participants Last post by  Intergrali
Try this then see if you still want to buy Challenger this is for all you cheapskates out there.
Take an old fly viper remove the ceramic magnet and fit 2 oblong neo mags ,stacked,as near to the rear axle line as possible ,you will need to cut the chassis to accept these.Tape the contoller in the full on position . Put the car on the track and it will probably go round flat out (it does on my track ,60ft polistil 3.8 secs, and also round a carerra oval)if it doesnt , add a couple of tweakers or another bar mag inside the chassis .Now try and race against it ,if you have unequal lanes put the mag car on the inside ,you will struggle to beat it .
Total cost 2-3 bar mags + 1 old fly viper
Cheers
Ebeneezer Scrooge(keeping down the cost of Christmas)
1 - 1 of 4 Posts
I think professor fate once suggested, you could also go with less magnet, and use some tape on the rail to stop electrial contact at the corners. Trial and error will allow the car to run round the track consistently.

See less See more
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top