SlotForum banner
1 - 5 of 5 Posts

· Premium Member
Joined
·
1,283 Posts
Discussion Starter · #1 ·
Hi guys
So just chip a gt40 and as am driving it around the track it keeps changing ID
without coming off or crashing or running over LC's.
It mite do a couple of laps then just stops along a straight
pick up anther controller and car has changed not always to same one.
Has done this now about 30 times
any answers guys ?
Ps is a C7006 solder chip.
regards ade
 

· Premium Member
Joined
·
1,283 Posts
Discussion Starter · #3 ·
Hi ade
only got the ferrite man on motor end it one of the old push in pickups.
which i solder on the side of the wire spades which is what i do to all the old cars ive chipped.
plus just done 2 gt40's this morning and the other one is ok .
will try lifting car and trying when I go back up to the loft later after lunch.
regards ade.
 

· Premium Member
Joined
·
1,283 Posts
Discussion Starter · #4 ·
Hi
OK tried with car jacked up and nothing happen .
So back on track
Id to White done 7 laps then lost ID
it went to Yellow done 6 laps then lost ID
Orange done 5 lost ID
White again 6 lost ID
Green 8 Lost ID
Blue 9 Lost ID
Red 20 laps end of fuel
This is strange never had this before used all colours
White twice then stayed on red till out of fuel
what the f##k is the problem.
regards ade.
 

· Premium Member
Joined
·
1,283 Posts
Discussion Starter · #8 ·
Hi Greg
Yes got LC's in layout but it seems to happen on along straight most of the time.
I even crashed the car and made it deslot a few times but didnt lose ID .
Im using newest firmware .
ade.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top