SlotForum banner
1 - 3 of 3 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi all.

For my final year project at uni I am going to write some software for the 6CPB. At the moment I am having problems receiving any data from the COM port.

The connection to the COM port is successful. If I remove the USB it throws an error. The state of the problem is that I'm not receiving any bytes of data.

The only other thing I have noticed is that when I pull the trigger on the controller the car still works. I was under the impression that when the PB is connected to a PC, the cars depended on receiving input from the PC and if there was no input from the PC then the cars would not move?

Below is the protocol info I have set so I don't think this is the problem.

1 start bit (0)
8 data bits
1 stop bit (1)
No parity bit
Baudrate: 19,200bps
USB Serial Port (COM4)

Any ideas what could be wrong?

Thanks,
Simon.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top