SlotForum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
4,634 Posts
Discussion Starter · #1 ·
I have a Fly corvette, and an overdrive lighting kit - with rear lights + additional brake lights. My question is about the real corvette: which way round do the rear lights go? is the rear lights on the outside, and the brakes on the inside, or vice versa?

cheers Dave

(PS to mods - not sure if this was about cars, master classes or something else!)
 

·
Allan Wakefield
Joined
·
5,857 Posts
Astro - I have the solution for you, using the kit you already have plus and extra set of rear LEDs ( preferably 5mm)...

Klaus from Overdrive will post here later tonight with the answer.
 

·
Registered
Joined
·
4,634 Posts
Discussion Starter · #6 ·
thanks swiss, i look forwards to klaus' advice.

I also have another question, about the 2 white wires for front lights. I am planning to have 2 sets (4) front lights. Does it make a difference if I run them all off the same white wire, rather than using 2 wires? I ask because one of the white wires fell off.

Cheers

Dave
 

·
Allan Wakefield
Joined
·
5,857 Posts
Again, Klaus can answer better than I but I think you need both white wires, they are easy to solder back on if you are quick with a soldering iron
 
1 - 7 of 7 Posts
Top