SlotForum banner
1 - 2 of 2 Posts

· DT
Joined
·
8,026 Posts
I have a 6 amp 0 to 20 volt power supply connected to my 4-lane track through Sport power bases. It works fine and I have full control to run a variety of cars. I let the kids who are likely to crash 'n' smash start off on lower voltages (10V) and then work their way up. I use Parma Eco 25 ohm controllers. Check it out here.
 

· DT
Joined
·
8,026 Posts
I did get it from Pendle. I think mine is one model up from the one in your stats. If you're running only 2 lanes it will be OK, but if you wish to run 4 lanes one day, you'll need at least 6 amps.

I have 4 pairs or 15 amp cable going up from the transformer to each power input socket on the power-bases. The little blue slider swich onthe power-bases are set to twin power so each lane gets its own 'clean' power.

Pendles can supply the Sport power-base plugs too. Just ask.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top