SlotForum banner

1 - 19 of 19 Posts

·
Living the Life!
Joined
·
11,082 Posts
It's a 4 pin JST (Japan Solderless Terminal) 2.0 plug. You can find then in the usual place but the ones used for RC things tend to have rather stiff wire. Keeto used them before he went to the micro JST 1.0 plugs on his Incar-Pro chips.
 

·
Living the Life!
Joined
·
11,082 Posts
dead link .............
 

·
Living the Life!
Joined
·
11,082 Posts
They are the right size but they do have the very stiff wire on the plugs.
 

·
Premium Member
Joined
·
1,294 Posts
Discussion Starter · #9 ·
Hi guys
these Micro JST 2.0 PH 4-Pin Connector do maplins sell them can not find any four pin connectors on there site?
ade.
 

·
Premium Member
Joined
·
10,109 Posts
No, the only one they do is part of a PC fan control and costs £8. I was desperate at the time....
 

·
Premium Member
Joined
·
1,294 Posts
Discussion Starter · #11 ·
Hi
so any where I can buy these ?
looked on the bay and there from china
but wanted them this week .
ade
 

·
Living the Life!
Joined
·
11,082 Posts
If you are really desperate ........ PM me
 

·
Registered
Joined
·
325 Posts

·
Registered
Joined
·
325 Posts
Anybody....?
 

·
Registered
Joined
·
325 Posts

·
Registered
Joined
·
325 Posts
And the verdict.....

A perfect fit!!!!!

Now for all your classic (F1) cars or other uses with very little space available....The way to go! Not only are the F1DPRchips the cheapest chips on the market nowadays, (maybe that will change because of increased demand now that this is out
) but they take up the very least amount of space (especially if you take the cover off, and turn the led into a remote led with wires (like the old F1 chip)




The wires are nicely pliable, they are even better than the ones Scalextric use in the contemporary F1 cars.



I like!!!!
 

·
Registered
Joined
·
458 Posts
I found à LOT of those kontakts in à retaried printer.
Its East to find
Ad if people dontgive you the answer fast enoegh!
Its wrong to start searching and Ale critisism says Lasp
 

·
Registered
Joined
·
325 Posts
QUOTE (MrFlippant @ 16 Mar 2012, 16:48) <{POST_SNAPBACK}>I bet if you wanted to, you could pry the plastic hooks up to slip out the wires and pins, then put them back in the proper color order for other chips.


Quite a good idea, to keep the color code standard!
Thanks!
 
1 - 19 of 19 Posts
Top