SlotForum banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
404 Posts
Discussion Starter · #1 ·
hi guys,

I don't remember if someone has token about this :

1 - Is SSD electric signal on rails a square signal between -12v and +12v


2 - Is SSD power base output protect against short circuit


thanks
 

·
Beppe Giannini
Joined
·
1,696 Posts
Bonjour David,

nice to hear from you again ! Are you getting SSD for your track ? I definitely would recommend it - it works very well and should adapt easily to your requirements

I can't help too much with your questions - I think we'll have to wait until lordjw or SWoRd get their hands on it - there should be short circuit protection on the output, on another thread they were complaining that even a momentaneous short on the brushes causes overload alarm and cancels the race

What I've found is that the 3-pole jack that connects the sensor half-straight to the LC is readily available - so it's very easy to access the impulse to the elecromagnet corresponding to lane change and use it as a trigger for your own circuit, that's what I'm doing right now

Ciao

Beppe
 

·
Premium Member
Joined
·
404 Posts
Discussion Starter · #3 ·
Hi,

Thanks Beppe, it's a good beginning of answer.

Of course, I want to addapt SSD to my track. but I have to take power supplie for my sensors on +12v and on -12v, on different spots.

I have buy my SSD set on line in France, but France SSD importing is not very active. The result is = I'm wayting
, and it's very difficult to wait when i'm just near the end.

regards,
 
1 - 3 of 3 Posts
Top