SlotForum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter · #3 ·
Hi David,

The initial table size was 4x11 and my options for Track on were limited because I had need of a Pit Lane. So the initial track was about 24 feet in length each lane. The original track design while it contained 1/60 curved sections all were "eased" by using 1/30 ,2/30, or 3/30 Pieces. ( Carrera obviously). The added on section was 4x5 enabling the Fly over and the Limiting Curve on it is 2/30. I am currently using the Carrera Borders mostly to protect the Walls of the room <lol> . The Flyover curve will have a Barrier of some sort and I am probably going to add a small section of Plexiglass as well. I should mention that the Floor is finished Concrete and a Car will likely not survive a fall without sustaining considerable damage.

I wasn't aware of any Particular Crash fencing available which also limited my choices.
 
1 - 4 of 4 Posts
Top