SlotForum banner
1 - 1 of 1 Posts

· Registered
Joined
·
398 Posts
Good going bill; for a first time job. Now just make it simpler and leave out the top of the chassis and concentrate on the bottom part and keep the weight down low. Keep as much weight below the center line of the axles as you can.

Scribe some set up axle alignment cross lines on a building board with a slot cut in it. Blacken them with a pen so you can see them. Use them to align your axles square to each other. That is if you don't have a building jig yet.

The distance across each axle front to rear and from side to side should be very close to each other to have a straight and true running car.

Keep em coming, your hooked


Larry S.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top