SlotForum banner
1 - 2 of 2 Posts

·
Digital "Tea Boy"
Joined
·
777 Posts
Discussion Starter · #1 ·
Hi all......

Is there a possibility of "blowing" the IR sensor and the the guide sensor boards? I can't see anything obvious on the boards but they have stopped working during my 4 lane start/stop conversion.....
 

·
Phil Kalbfell
Joined
·
3,373 Posts
I have some here that don't work, so far I have repaired two of them. One dry joint the other simply a broken track on the board.Check that the rails have power on them,often a poor connection to the tracks either side.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top