SlotForum banner
1 - 1 of 1 Posts

· Registered
Joined
·
3,267 Posts
Markus,

I tried to repost your picture. The metal ends for the wires and pushed into the plug after the wires are connected. They can be removed. If you look very carefully at the 4 shinny bits in your picture you will see they are sprung loaded barbs. You'll need a very small screw driver or a pair of tweezers or something and if you are as old as me
a magnifying glass.

Put the plug on a firm flat surface and push down on the shinny bit and lever it out of the white plastic. If you have tweezers you can pull with them while pushing down on the metal with something else. The metal part will come out of the white plastic and you can re solder the wire to the metal then push the metal back into the white plastic.

In your picture the colour order for the wires is green, red, yellow, black on the end.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top