how do i design an equall lane length track

4605 Views 20 Replies 12 Participants Last post by sealevel, Apr 21, 2012

stoner

Discussion Starter · Apr 20, 2012

hy, i,m going to route a track.[my ninco has so many lumps and bumps where the grandkids walk all over it]. the space is 16ft by 6ft 2 lane. i only have 2 criteria, it must have a long straight at the back with 2- 5ft6in outside radius bends on each end of the straight. the middle can be filled with anything as long as the lap lengths are roughly equall. could someone point me in the right direction. thanks. john

Save

1 - 1 of 21 Posts

ncng

· #12 · Apr 21, 2012

In both HO and 1/32 track and routed stuff, I have always used a cloth taylors tape measure and the stratigic cross over and wide turns.
Then in my case of 2 and 4 lane tracks, all lanes are equal, after track is built, fastest lane is pole lane, and on with how each lane performs.

ncng

Save

1 - 1 of 21 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month