SlotForum banner
1 - 1 of 1 Posts

· Registered
15 Posts
Discussion Starter · #1 ·

Could someone please explain in an exact way how to break in a motor under water/oil.

I have been told you can break motors in under both??

Do I submerge all the motor including wires?

What voltage should I run while under water/oil

How about 3 mins in water, 30 secs in wd-40, 3 mins spinning dry to dry off, all at 3v????

Any info appreciated.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.