SlotForum banner
1 - 2 of 2 Posts

· Registered
Joined
·
391 Posts
Hi all; as Edo said, I too have used here in Italy a fluid sold by "MB"; my first impressions are positive. First I have made a rpm reading at 12v of a used Fly motor; it turned 18900 rpm; soon after I have fully immersed the motor in the fluid and run it at 4v for 5 minutes; then for 10 seconds backwards. The final reading was 22100 rpm. I don't know if this will last or if I have broken the motor; until now I have used it for two hours and it goes well.
Other Fly motors, all used, have shown all a gain in rpm after the bath, albeit not so high.
I will soon try the fluid for break-in.

P.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top