SlotForum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I hope there is someone out there that can help me out. I was given a Scalextric GT40 it used to be an analog car and someone has soldered a chip into it, well the chip has burnt out and i want to remove the chip and put it back to an analog car. So is there anyone that can tell me how to do this or send me a photo on how to do it, have got as far as removeing the black and red wires from the sensor pick up but don,t know about the rest of the wireing.
 

·
Greg Gaub
Joined
·
15,076 Posts
Just remove the whole lot of it and put down new wires from the guide to the motor. If the car runs in reverse, swap the wires.
 

·
Living the Life!
Joined
·
11,082 Posts
Here you go .......

View attachment 8999

The white wire runs from the right hand side to the rear solder point on the motor. You will probably need to add the "Ferrite man" as well; that's the capacitor and small black choke.

Welcome to the forum

All the best - Greg
 
1 - 3 of 3 Posts
Top