SlotForum banner
1 - 3 of 3 Posts

·
Mike
Joined
·
629 Posts
Discussion Starter · #1 ·
I have had intermittent problems with my porsche chip and find that the black wire that goes from chip to motor has come off I would like to know which pad to connect it back to as I can see no obvious signs of solder or wire on the module.
it is the chipped from the factory car
Ta for any help
Mike
 

·
Living the Life!
Joined
·
11,082 Posts
You are in luck ........... I finally found the one "old" chip that I had.

View attachment 9045

The black wire is shown on the left of the capacitor. When the car is in it's normal position, the black wire is directly underneath the red wire and the very last solder connection on the board.

Now would be a good time to replace the wires with some nice soft silicone ones. Just shout if you need any more help or even silicone wires.

All the best - Greg
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top