SlotForum banner
1 - 2 of 2 Posts

· Registered
Joined
·
2,085 Posts
What power supply are you using? Im pretty sure the old classic track needed a DC power supply. The new track uses an AC power supply and then this is converted to DC on the power track section. Check your wall wart power supply and see if it is AC or DC output.

cheers
rick1776
 

· Registered
Joined
·
2,085 Posts
Is this happening on the power track section itself? Or as you go from track section to track section? The rails are nickel coated steel. The coating is VERY thin. Once its gone there is not a lot you can do. Savage cleaning like you have suggested will only be a very short term solution and will cause the mild steel to rust at an accelerated rate. Lots of people buy copper tape and place this on top of the rails.

cheers
rick1776
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top