SlotForum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
Is it possible to have a 4 lane start/Finish line in scalextric digital ?

Can extra sensor's be wired in to count laps in the extra 2 lanes at a start/finish line ?

Thanks
 

·
Registered
Joined
·
55 Posts
Yes, for the older PB6. I've seen an article on here about it. Something about wiring them in parallel, or something. Some comments about risk when cars cross line at same time. No idea when would happen with the newer APB6 - it might get confused and think things are going backwards, who knows.

TT
 

·
Premium Member
Joined
·
702 Posts
Yes,

I have a separated four lane start finish that I can use with either my PBPro-SH or my APB.



See the link in my signature and also search on here, there are two or three threads about this.

Be careful with the wiring. I have a wiring schematic diagram for it you can have if you PM me.
 

·
Registered
Joined
·
28 Posts
Discussion Starter · #5 ·
ah ok, great.

I'm still researching all the posibilities with digital.

I haven't as yet done the change over.

Thanks
 

·
Administrator
Joined
·
10,131 Posts
Yes it is possible, I did a thread on it a few years ago. I have only done one conversion of C7042 to 4 lane, but it uses all the same bits as before.
 
1 - 6 of 6 Posts
Top