SlotForum banner
1 - 1 of 1 Posts

· Registered
98 Posts
Hi Don

I have some info that may help.

I have fit a couple of HRS chassis to Rally cars and have found that the minimum width of rear axle achievable is a massive 56mm, to achieve this I used short hub wheels and ground the walls of the tyres down to the edges of the wheels. Slot it designed their chassis to use all three configurations, so even if you choose to use an inline it is no narrower. I personally would like to see them produce an inline only chassis which could be made narrower.

As for the MSC chassis, I dont have one but the inline version looks narrower. Pendles have the anglewinder version.

Good Luck

P.S. Ive just looked again. You may be able to squeeze to 55mm.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.