SlotForum banner
1 - 2 of 2 Posts

· Senior Slot Car Mechanic
Joined
·
2,221 Posts
Verry verrrry nice,one of my all time favorite cars.

If it isn't too late,you might want to consider moving your closing panels back just slightly,as on the real cars,these end panels were not flush,but inset a little bit leaving a slight forward facing flange on the leading edge of the paniers.The front and back outer edge of the paniers was also radiused to match the tires when seen from a side view.
 

· Senior Slot Car Mechanic
Joined
·
2,221 Posts
QUOTE but trim most of it since it will no longer swivel. I'm a little concerned about strength. Let me know what you think.
Just cut the blade right off,drill a hole in the base,and squeeze in a bit of the red tubing that comes on contact cleaner spray cans,that's what I use.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top