A couple of my cars pickkup guides that sit in the slot keep smacking hard into the plastic V shape intersecting point situated in the slot where slot changes directions & the X section.
I might need to clarify the exact problem region where it is hitting.. I don't mean the V point on the metal flipper... but the actual X section. The plastic crossing point, hope this helps...
I'm thinking the best solution is to simply file back the tip of the V inside the curve till the cars change lanes smoothly.
But am I missing the point somewhere (pardon the pun )
I also notice one of the cars pickup guides that drop down into the slot is not always centered. It seems the positive wire is putting a little tension on the guide, rotating it slightly to the left making it off center.
Any suggestions would be greatly appreciated before i go about butchering my track piece.