I used a layout I saw on here as a sort of base
will the new APB be OK there? Have not picked it up yet
will the new APB be OK there? Have not picked it up yet
Layout feedback
Thinking about building this layout:
![]()
What do you think?
too many R1?
XLC too close to R1 , turn 10?
I just put xlc wherever they would fit, you don't have to use it
![]()
![]()
What do you think?
too many R1?
XLC too close to R1 , turn 10?
I just put xlc wherever they would fit, you don't have to use it
3
1 - 4 of 13 Posts
updated based on feedback:
![]()
temp table with all sides open for standing cornering etc
I like bank corners, and have some, but I find I can't put an XLC on entry to a bank unless it is 1.5 straights away as the bank tilts the track
I do have two grabbers but kind of forgot about the reach issue, I just designed it to fill my max area.
temp table with all sides open for standing cornering etc
I like bank corners, and have some, but I find I can't put an XLC on entry to a bank unless it is 1.5 straights away as the bank tilts the track
I do have two grabbers but kind of forgot about the reach issue, I just designed it to fill my max area.
It will probably end up mostly just me and two ghosts
![]()
but the max I have run and like to run is four, with two ghosts w/ mags each locked to a single lane, one inside one outside
All my setups are temp until the wife comments ...
still trying to work out a temp 'table' setup that is light enough for a person with bad back to setup.
but the max I have run and like to run is four, with two ghosts w/ mags each locked to a single lane, one inside one outside
All my setups are temp until the wife comments ...
still trying to work out a temp 'table' setup that is light enough for a person with bad back to setup.
1 - 4 of 13 Posts
