SlotForum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
17 Posts
I finally finished this car last night after working on it on and off for quite a while.

I heard great things about the Sloter Lola's, unfortunately mine was pretty poor when I got it. None of the wheels were round, and the bushing carriers were really bad. So I decided to put a proper chassis under it!

Used an older 312pb chassis I had as a parts car.

Materials used:

.032" front and rear pans

.063" side pans

.055" main chassis rails

WRP guide tongue

Samson Classics Guide Tube

Pod is reamed and I used 2-56 screws and nylocs to hold it in. It sits on top of 3mm thick rubber washers.

Since this car isn't the best "scale" appearing car anyhow I was more focused on performance. So I installed a paper interior, with a hand painted driver.

It needs a little more motor, but it handles very well!

49731372073_88dd760553_k.jpg

49731372833_f74c534ffd_k.jpg

49732243377_e7f35e0e34_k.jpg

Zack
 

·
Premium Member
Joined
·
3,013 Posts
Zack,

that does look rather good , is that the original livery, or did you source them from somewhere?

Simon
 
1 - 7 of 7 Posts
Top