[stoner]

MB slot is a racing brand, and i cant see them putting out a product without being satisfied its fit for purpose. i should imagine its a very tight interfearance fit, that needs mechanical puller and pushers to get them on or off. john

 

[stoner]

we,re really arguing about top racers in world finals. if it gives you 1inch more per lap its a better product. john

 

[stoner]

that was just an extreme situation i wrote to to get the point across and your not wasting your money, if you have to buy gears. their probably a lot cheaper than their metal counterparts. Theirs speed rings for less contact and friction and teflon washers with the lowest coeficient of friction known to man, and they dont have to be lubricated either. the gear and pinion if its adjusted right its the perfect solution, because you dont have to use any stoppers. in fact i think MB slot should send me a pair for testing seeing as i seem to be standing their corner in this debate. john

 

[stoner]

i think they do them in 2mm so when you strip them it leaves the right hole size to tap them 2.5 ect up to tapping 3mm

 

[stoner]

i would think their 50m pitch for 3mm axles. john

 

[stoner]

To MBslot really. Could i get away with using these gears on a 1/8 axle without warping or splitting them. Or would i have to ream them 3mm to get a .0069 interference fit. John