Measures

1643 Views 5 Replies 4 Participants Last post by sprint, Jan 22, 2004

sprint

Discussion Starter · Jan 21, 2004

I want to order some K&S brass tubing to make bushings for the guide, but what is the correct diameter to buy that will fit in the chassis hole, and accept the guide without slop? ( here in Italy we work metric and I will buy via mail order from the States)
And what the diameter of a brass tube that will go over the front axle to make front wheel decoupling?

Thanks!
Ciao
P.S. Do you know if also in U.K I could buy this brass tubing through mail order?

See less See more

Save

1 - 1 of 6 Posts

Xlot

· #3 · Jan 21, 2004

Ciao Sprint,
unless I'm mistaken K&S tubing (and plates) is carried in Rome's model shops
Don't have the yellow pages here, but I believe I saw it in the one in Via Oderisi da Gubbio (or near Piazzale della Radio)
BTW : where do you race ? Otello?

Beppe

Save

1 - 1 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month