SlotForum banner
1 - 1 of 1 Posts

· Registered
Joined
·
262 Posts
Hi, I allway's make my own spacer's from the clear plastic packaging that a lot of item's not only slot related come in with thin and thicker type's it offer's adjustability, I just use a pinvise to drill a hole in the plastic say 2.5mm cut out a square around the hole about 5mm then trim the corner's to make it a bit more rounder then cut a V into the hole to leave it like a circlip them with needle nosed plier's clip on to axle. With a larger gap I use tube spacer's I have some of my nephew's old paper flag's we got from Mac's which have just the dia needed plastic flag stick don't think they do them anymore( could see dad going in to get a Happy meal for the kid's just to get the flag's ). phil.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top