Joined
·
1,987 Posts
QUOTE When fitting a long can motor into the SCX pod I space the axle so that the motor shaft is not required to hold centre the axle in the chassis
That's the way to do it. You can use brass tubing either side of the axleshaft or simple spacers between the wheel and bearing. Easy.
Otherwise you'll only have a tiny range of motors with a long enough shaft.
That's the way to do it. You can use brass tubing either side of the axleshaft or simple spacers between the wheel and bearing. Easy.
Otherwise you'll only have a tiny range of motors with a long enough shaft.
