SlotForum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3,147 Posts
Mine doesn't have that problem but the separate brass "guide" thingy next to the crown, that is not connected to the gear, did move. Until I tightened it.

Best bet would be to loosen the crown, slide it to one side and file a small flat on the axle.

If you must, a small drop of super glue on the end of a pin into the gap between the axle and gear may suffice. Easily removed with nail polish remover (acetone).
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top