A while ago I was given a new Ninco NC-4 motor with two adapters in the pack. I have come to fit it into a Scalextric chassis, but the adapters will not hold the motor in place. The Scalextric chassis holds the NC-4 motor at one end okay, but the motor needs to clip onto the two side lugs on the chassis to support the other end. There are no dimples on the motor for these lugs to fit into.
Is there a simple adapter for this or will I have to carry out a chassis modification?
Any help or advice would be greatly appreciated.
Mike
![]()
Is there a simple adapter for this or will I have to carry out a chassis modification?
Any help or advice would be greatly appreciated.
Mike
