SlotForum banner
1 - 5 of 5 Posts

· Registered
Joined
·
3,558 Posts
Discussion Starter · #1 ·
ive just got a ninco 35ohms controller and ive wired it up to standard parma colours. its 4 wires out of the controller all soldered to a circuit- wiper board. can you tell me if i,ve done it right. the black and red wires go together and go to the full speed end of the resistor= parma white. the yellow wire goes to brake post-start of the resistor=parma red. and green wire goes to trigger-resistor wiper=parma black. john
 

· Registered
Joined
·
3,558 Posts
Discussion Starter · #6 ·
thanks beardy, thats the diagrams i used to wire my track, +polarity with reversing switches and a voltage controller. the ninco did work the way i had it. i,ve just soldered in some heavier wire in parma colours. john
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top